BONDSTRAND - SPECIFICATIONS

Pipe Construction

The structural wall of fiberglass pipe in 1 through 40-inch sizes shall have continuous glass fibers wound at a 54¾ helical angle in a matrix of aromatic amine cured epoxy resin. 

Pipe in 1 through 40-inch sizes shall be rated for a minimum of 232 psig at 200°F with a safety factor of 4:1 and shall have a full vacuum capability with a safety factor of 3:1, as required in applicable standards.

Pipe and fittings shall meet the requirements of ASTM F1173 for fiberglass-reinforced epoxy pipe and fittings for shipboard applications.

Filament-wound epoxy fiberglass pipe shall be translucent to the point where damage which may have occurred during handling is visible upon visual inspection.

  

2000M

The integral reinforced resin-rich liner (if necessary) shall consist of C-glass and a resin/hardener system identical to that of the structural wall, and shall have a 20-mil nominal thickness.

Pipe shall be manufactured according to ASTM D2996 Specification for filament-wound reinforced thermosetting resin pipe (RTRP).  When classified under ASTM D2310, the pipe shall meet Type 1, Grade 1 and Class F (RTRP-11FE) cell limits.

  

7000M

Pipe shall be manufactured according to ASTM D2996 Specification for filament-wound reinforced thermosetting resin pipe (RTRP), together with high strength, conductive carbon filaments. When classified under ASTM D2310, the pipe shall meet Type 1, Grade 1 and Class A (RTRP-11AE) cell limits.

  

2400

The integral, reinforced resin-rich liner (if necessary) shall consist of C-glass and a resin/hardener system identical to that of the structural wall, and shall have a 20 mil nominal thickness.